SerVision CVG-M Technické informace stáhnout pdf (Strana 16)

SerVision Embedded Video Gateway System Guide

Getting Started 15

6. In the Save Settings screen, click Save Changes to System. The unit stores the changes permanently, and

the System Restart Page screen opens:

Figure 13: System Restart Page screen

7. Click Restart System. The unit restarts, and the changes are implemented. You are automatically logged out

of the configuration utility.

Note: Most changes to the settings in the configuration screens only take effect on the Video Gateway unit

after they are saved and the unit is restarted, as describe in steps 5–7. For additional information, see Saving

Configuration Changes, page 125.

Note: For security reasons, a configuration session times out after 15 minutes. If the configuration utility is

open with no user activity (pages loaded) for more than 15 minutes, you must perform the login procedure

again to continue configuring the Video Gateway unit. Configuration changes that were made during the

timed-out session are not discarded, as long as Update was clicked in the relevant screen before the time-out

occurred.

Opening the Configuration Remotely

Once the unit has been configured for remote client access via the internet (see LAN Settings, page 38), you can also

access the configuration utility remotely via the internet. To do this, all you need is a PC that is connected to the

internet. You can then access the configuration utility in one of the following ways:

 Through the MultiClient: Connect to the Video Gateway and use the MultiClient to access the configuration

utility, as explained below. (For additional information about working with the MultiClient, please refer to the

MultiClient User Guide.)

 Manually through a browser: Enter the address and port in the Address field of a browser window, as

described under Opening the Configuration Manually, page 16.

Both of these methods can also be used to access the configuration utility over the internet through a proxy

connection.



To access the configuration utility remotely through the MultiClient:

1. Connect to the Video Gateway through the MultiClient.

Note: The MultiClient's Search function does not work over the internet. Therefore, you will have to

manually add and configure the connection to the Video Gateway. For information about how to do this,

please refer to the MultiClient User Guide.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 202 203

Žádné komentáře

SerVision CVG-M Technické informace Strana 16