SerVision CVG-M Technické informace stáhnout pdf (Strana 173)

SerVision Embedded Video Gateway System Guide

Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 172

 Mouse/Touch: HVG and UVG models are supplied with a mouse. If the mouse is connected to the Video

Gateway, you can use it to perform a variety of operations on the monitor: changing the sizes of the camera

panes, selecting cameras, activating PTZ camera controls, and playing recorded video. The same operations

can be performed on MVG, CVG, and CVG-M units if they are connected to supported touchscreen monitors.

In this case, touching the screen activates the same features that would be activated on the other models by

clicking the left mouse button.

 Push-button switch: If a switch is connected to the relevant sensor connector on the rear panel of the unit,

you can use the switch to cycle through the various available display types. However, you can only view live

video, and PTZ controls are not available.

NOTE: Mouse/touch controls only work if they are enabled in the configuration, and a push-button switch can

only be used if the relevant sensor connector is configured properly and the option is enabled. For

additional information, see Configuring a CCTV Monitor (TV-Out), page 28; Configuring a Sensor to

Control CCTV Display, page 116.

The rest of this appendix explains how to use the mouse/touch controls to perform various operations. For

information about connecting the supplied mouse or a supported touchscreen monitor, please refer to the Video

Gateway unit’s installation guide.

NOTE: If you are using a touchscreen, it is recommended that you calibrate it before you use it for the first

time. For information about how to do this, please consult the manufacturer’s documentation or your

vendor. In addition, for optimal precision and sensitivity, it is recommended to use a pen, a pencil, or a

stylus to tap the screen. Do not press hard or stab the display – the screen is quite delicate!

Using Mouse/Touch Controls

If mouse/touch controls are set up and enabled on your Video Gateway (see page 172), you can perform the

following actions:

 Switch from split-screen to full-screen display

 View recorded video

 Edit and download recorded video

 Configure picture and display properties

 View system settings

 Control PTZ cameras

These actions are performed through a menu that can be displayed on the monitor’s screen.



To open the monitor’s main menu:

 Click/tap anywhere on the screen. The menu is displayed on the left side of the screen. A single quarter-screen

camera pane is displayed in the upper-right corner of the screen.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 202 203

Žádné komentáře

SerVision CVG-M Technické informace Strana 173