SerVision CVG-M Instalační příručka

CVG-M Installation Guide September 2013

SerVision CVG-M Installation Guide Installing the CVG-M System 9 Figure 2: Video Gateway installed in an insulated container and attached to the ba

SerVision CVG-M Installation Guide Installing the CVG-M System 10 Diagrams of Connectors The rear and sides of the CVG-M unit contain the following

SerVision CVG-M Installation Guide Installing the CVG-M System 11 Connector Description Modem Antenna Connector for the supplied cellular-modem a

SerVision CVG-M Installation Guide Installing the CVG-M System 12 Figure 7: Connecting cameras to the power supply through the Activator connector

SerVision CVG-M Installation Guide Installing the CVG-M System 13 Figure 8: Placing a transformer between the vehicle battery and the devices draw

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 14 Connecting Devices to the CVG-M This section explains how to connect devices s

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 15  To connect an RS232 PTZ controller: The RS232 controller cable should end wi

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 16 Connecting Sensors Sensors are devices that detect events such as a door being

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 17 Connecting Sensors Using an ADAM Module If you want to connect additional dry

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 18 Figure 16: Connecting sensors to the ADAM-4051 module 3. Connect the ADAM-40

SerVision CVG-M Installation Guide 1 Trademarks & Copyright Trademarks All trademarks mentioned in this manual are the sole property of their

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 19 Figure 17: RS232/485 adapter Note: If you connect an ADAM module to the unit,

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 20 Figure 18: Connecting the module to the converter, the CVG-M, and the power s

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 21 Figure 19: Connecting an activator that has its own power supply 3. Connect

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 22 For information about connecting sensors and activators to the IA 3126-2 relay

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 23 2. Plug the microphone connector into the Audio In (Ain1) connector on the si

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 24 When choosing a monitor to connect to the unit, ensure the monitor supports th

SerVision CVG-M Installation Guide Connecting Devices to the CVG-M 25 Figure 23: RS232/485 adapter 4. If the monitor is touch-sensitive, it is rec

SerVision CVG-M Installation Guide Connecting the CVG-M to a Network 26 Connecting the CVG-M to a Network The CVG-M can be connected to a local netw

SerVision CVG-M Installation Guide Connecting the CVG-M to a Network 27  To insert a SIM card into the unit: 1. Using the tip of a paper clip, a b

SerVision CVG-M Installation Guide Connecting the GPS Antenna 28 Connecting the GPS Antenna A GPS receiver is built into the CVG-M unit. When the GP

SerVision CVG-M Installation Guide 2 Table of Contents Introduction 3 The CVG-M Package 4 Additional Equipment 6 Installing the CVG-M System

SerVision CVG-M Installation Guide Connecting the CVG-M to a Power Source 29 Connecting the CVG-M to a Power Source The CVG-M can be connected eithe

SerVision CVG-M Installation Guide Connecting the CVG-M to a Power Source 30 Figure 29: No wire connector connected to Power connector Figure 30:

SerVision CVG-M Installation Guide Connecting the CVG-M to a Power Source 31 3. Connect the power supply cable to the Power connector on the unit.

SerVision CVG-M Installation Guide Connecting the CVG-M to a Power Source 32 Figure 32: Wire connector Figure 33: Wire connector plugged into Powe

SerVision CVG-M Installation Guide Connecting the CVG-M to a Power Source 33 Figure 35: Connecting the IGN connector to the (+) connector when a c

SerVision CVG-M Installation Guide Appendix 1: Removing the MicroSD Card 34 Appendix 1: Removing the MicroSD Card The CVG-M unit stores all recorded

SerVision CVG-M Installation Guide Appendix 1: Removing the MicroSD Card 35  To insert a microSD card into the unit: • Hold the card as illustrate

SerVision CVG-M Installation Guide Appendix 2: Using the 12VDC Power Out Connector 36 Appendix 2: Using the 12VDC Power Out Connector The CVG-M can

CVG-M Installation Guide POB 45205 Jerusalem 91450 Israel Tel: +972-2-535 0000 • Fax: +972-2-586 8683 www.servision.net • info@servision

SerVision CVG-M Installation Guide Introduction 3 Introduction This guide explains how to set up the hardware components of SerVision’s CVG-M securi

SerVision CVG-M Installation Guide The CVG-M Package 4 The CVG-M Package The CVG-M package contains the following items: Item Description Illustra

SerVision CVG-M Installation Guide The CVG-M Package 5 Item Description Illustration Power-supply cable Connects the power-supply to the unit Note

SerVision CVG-M Installation Guide Additional Equipment 6 Additional Equipment One or two video cameras should be connected to the CVG-M. You must a

SerVision CVG-M Installation Guide Installing the CVG-M System 7 Installing the CVG-M System These are the steps that you will typically follow in o

SerVision CVG-M Installation Guide Installing the CVG-M System 8 the paneling, of a car. Ensure the unit has at least 20 centimeters (eight inches)