SerVision CVG-M Instalační příručka stáhnout pdf (Strana 19)

SerVision CVG-M Installation Guide

Connecting Devices to the CVG-M 18

Figure 16: Connecting sensors to the ADAM-4051 module

3. Connect the ADAM-4051 module to the ADAM-4520 isolated converter as follows (see figure 18, page 20):

Connect this connector on

the ADAM-4051

To this connector on the

ADAM-4520

(Y) Data+ Data+

(G) Data- Data-

(R) +Vs (R)+Vs

(B) GND (B)GND

4. Connect the ADAM-4520 isolated converter to the RS232/485 connector on the rear panel of the CVG-M unit

in one of the following ways:

•

If you are not connecting any RS485 PTZ controllers to the unit, using the 9-pin flat ribbon cable, connect

the RS232 connector of the ADAM-4520 converter directly into the RS232/485 connector.

•

If you are also connecting one or more RS485 PTZ controllers to the unit, using the 9-pin flat ribbon

cable, connect the RS232 connector of the ADAM-4520 converter into the RS232 connector of the

RS232/485 adapter supplied with the unit. Connect the PTZ controllers to the adapter as explained under

Connecting a PTZ Controller, page 14. Then plug the adapter into the RS232/485 connector on the unit.

D GND

Connect sensor ground

wires to this connector

D1 0

through

D1 10

Connect positive (+) sensor wires

to these connectors

D1 11

through

D1 15

Connect positive (+) sensor

wires to these connectors

D GND

Connect sensor ground

wires to this connector

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Žádné komentáře

SerVision CVG-M Instalační příručka Strana 19