SerVision CVG-M Instalační příručka stáhnout pdf (Strana 14)

SerVision CVG-M Installation Guide

Installing the CVG-M System 13

Figure 8: Placing a transformer between the vehicle battery and the devices drawing power from it

Configuring the Power-Supply Activator

When the power supply to devices is routed through the activator connector, as described above, the activator must

be configured correctly in the CVG-M's configuration: the Normal Status of the activator must be set to Closed, as

in the illustration below. (For additional information about configuring the activator, please refer to the Embedded

Video Gateway System Guide, under Configuring Sensor and Activator Settings.)

Figure 9: Normal Status of activator set to Closed

Normal Status

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Žádné komentáře

SerVision CVG-M Instalační příručka Strana 14