SerVision CVG-M Instalační příručka stáhnout pdf (Strana 15)

SerVision CVG Installation Guide

Connecting Devices to the CVG 14

Figure 10: RS232/485 adapter

Note: If you connect an ADAM module to the unit, you cannot connect any RS232 PTZ controllers, a touch-

screen controller, or an IA relay board to the unit. For additional information, see Connecting a PTZ

Controller, page 9; Connecting a CCTV Monitor, page 18; Connecting Sensors and Activators Using an IA

Relay Board, page 16.

5. Connect the ADAM-4051 module to the power source as follows (see figure 11, page 15):

 Connect the positive (+) wire of the power supply cable to the (R) +Vs connector on the module

 Connect the negative (-) wire of the power supply cable to the (B) GND connector on the module

Note: Each of the power connectors on the module will then have two wires connected to it – one connecting

it to the power supply, and one connecting it to the power connectors of the ADAM-4520 converter.

Plug into RS232/485

connector on MVG

RS232 connector

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Žádné komentáře

SerVision CVG-M Instalační příručka Strana 15