SerVision CVG-M Instalační příručka stáhnout pdf (Strana 23)

SerVision CVG Installation Guide

Connecting the CVG to a Power Source 22

Connecting the CVG to a Power Source

The standard CVG must be connected to an electrical outlet using the supplied power-supply cable. Once it is

connected, the unit starts up automatically. During the start-up process, the Power LED on the top of the unit

flashes at various intervals. When the start-up process is completed successfully, the Power LED should display as

a solid color and blink momentarily every second. (Depending on the configuration settings, it should either be solid

orange and then blink green or solid green and then blink orange.)

Figure 17: Power LED

NOTE: When the start-up process is completed, if the Power LED does not flash – it displays as a solid green

or orange all the time – the start-up process was not successful. In this case, disconnect the unit from

the power supply and then reconnect it.

WARNING: Only the power supply cable that came with the unit should be used. Use of a power supply other

then the one provided in the package may cause irreparable damage to the unit. In particular, do not

use the power supply cable from an HVG 200 unit, because it will not supply sufficient power to

the unit. Furthermore, and most important, never use the CVG power supply cable with an

HVG 200, because this will ruin the HVG 200.



To connect the standard CVG to a power source:

 Connect the Power connector on the rear of the CVG unit to a standard wall socket using the supplied power

supply cable (see The CVG Package, page 4). The unit starts up.

Power LED

1 2 ... 18 19 20 21 22 23 24 25 26

Žádné komentáře

SerVision CVG-M Instalační příručka Strana 23